2020-01-14

Manual Release - Door - Rear - LH (Actuate)

Correction code 11358005 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

수동 해제 케이블을 이용하여 후면 도어 열기

Informational PurposesAn informational icon, calling your attention
참고
이 절차에서는 12V 전원이 공급되지 않는 차량에서 후면 도어를 수동으로 여는 방법을 설명합니다.
  1. 액세스 패널을 암레스트 하부에 고정하는 볼트를 탈거합니다.
    6 Nm (4.4 lbs-ft)
  2. 액세스 패널을 LH 후면 도어 암레스트 하부에 고정하는 클립을 분리한 다음 차량에서 액세스 패널을 탈거합니다.
  3. 픽을 사용하여 수동 해제 케이블을 암레스트 아래 개구부에서 끌어 당깁니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    수동 해제 케이블은 도어 패널 안 작은 구멍 뒤에 가려져 있습니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    이 단계에서 절연 폼이 손상될 수 있습니다. 폼 조각을 확인하고 제거하십시오.
  4. 수동 해제 케이블을 끌어 당겨 LH 후면 도어를 엽니다.
  5. 수동 해제 케이블에서 절연 폼을 제거하십시오.

Install

Installation procedure is the reverse of removal, except for the following:

수동 해제 케이블 링 위에 25mm x 64mm x 3mm의 새 접착 폼으로 감싸줍니다.