2019-08-13

Vent Hose - 12V Battery (Remove and Replace)

Correction code 17011002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
  2. 실내 흡기 덕트를 탈거합니다. 덕트 - 상단 - 실내 흡기(탈거 및 교체)을(를) 참조하십시오.
  3. 후드 래치 커버를 탈거합니다. Cover - Hood Latch (Remove and Replace)을(를) 참조하십시오.
  4. 후드 내 보관 유닛을 탈거합니다. Underhood Storage Unit (Remove and Replace)을(를) 참조하십시오.
  5. 12V 배터리의 LH 쪽에서 12V 배터리 벤트 호스를 탈거합니다.
  6. 12V 배터리 브래킷에서 12V 배터리 벤트 호스 클립을 분리합니다.
  7. 12V 배터리 벤트 호스를 차량에 부착해주는 클립을 풀어준 다음 벤트 호스를 탈거합니다.

Install

Installation procedure is the reverse of removal.