2020-02-26

Tweeter - Dash (Remove and Replace)

Correction code 21211802 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications: Tweeter - Dash (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
중앙 대시보드 트위터를 IP 캐리어에 고정하는 나사
2.3 Nm (1.7 lbs-ft)
  • Torx T20 비트
  • 래칫/토크 렌치
Reuse

Remove

  1. LH 및 RH 계기판 엔드캡을 탈거합니다. End Cap - Instrument Panel - LH (Remove and Replace)을(를) 참조하십시오.
  2. LH 및 RH 중앙 A필러 트림을 탈거합니다. Trim - A-Pillar - Middle - LH (Remove and Replace)을(를) 참조하십시오.
  3. LH 및 RH 상단 A필러 트림을 탈거합니다. Trim - A-Pillar - Upper - LH (Remove and Replace)을(를) 참조하십시오.
  4. 계기판 스피커 그릴을 탈거합니다. Grille - Speaker - Instrument Panel (Remove and Replace)을(를) 참조하십시오.
  5. 대시보드 트위터를 계기판에 고정하는 나사를 탈거한 다음 차량에서 트위터를 탈거합니다.
    2.3 Nm (1.7 lbs-ft)
  6. 대시보드 트위터 커넥터에서 전기 하네스를 연결 해제한 다음 차량에서 트위터를 탈거합니다.

Install

Installation procedure is the reverse of removal.