2024-04-08

Sensor - Pressure and Temperature (PT) - Low Pressure (Non-Heat Pump) (Remove and Replace)

Correction code 18205602 1.08 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. A/C 냉매를 회수합니다. 참조 항목: A/C Refrigerant (Recovery and Recharge).
    Informational PurposesAn informational icon, calling your attention
    참고
    이 절차를 수행하기 전에 냉매를 완전히 회수하십시오.
  2. 12V 전원을 연결 해제합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
  3. 저압 및 온도 센서의 전기 커넥터를 연결 해제합니다.
  4. 파이프에서 저압 및 온도 센서를 탈거합니다.
    7 Nm (5.2 lbs-ft)

Install

Installation procedure is the reverse of removal, except for the following:

  • A/C 냉매 재충전을 수행합니다. A/C Refrigerant (Recovery and Recharge)을(를) 참조하십시오.
  • Toolbox 3이 설치된 노트북을 차량에 연결한 후 다음을 수행합니다.
    1. Actions/Autodiag 탭에서 "reset vcfront"를 검색하고 TEST-RESET_VCFRONTvia Toolbox: (link)via Service Mode Plus:
      • Low Voltage ➜ Power Distribution ➜ Reset VCFRONT
      • Mid Voltage ➜ Power Distribution ➜ Reset VCFRONT
      을 선택하고 Run을 클릭한 다음 루틴이 완료될 때까지 기다립니다.
    2. Actions/Autodiag 탭에서 "thermal"을 검색하고 TEST-SELF_VCFRONT_X_THERMAL-PERFORMANCEvia Toolbox: (link)via Service Mode: Thermal ➜ Actions ➜ Test Thermal Performancevia Service Mode Plus:
      • Drive Inverter ➜ Front Drive Inverter Replacement ➜ Thermal System Test
      • Drive Inverter ➜ Rear Drive Inverter Replacement ➜ Thermal System Test
      • Drive Inverter ➜ Rear Left Drive Inverter Replacement ➜ Thermal System Test
      • Drive Inverter ➜ Rear Right Drive Inverter Replacement ➜ Thermal System Test
      • Drive Unit ➜ Front Drive Unit Replacement ➜ Thermal System Test
      • Drive Unit ➜ Rear Drive Unit Replacement ➜ Thermal System Test
      을 선택하고 Run을 클릭한 다음 루틴이 완료될 때까지 기다립니다.