2019-08-13

Antenna - Wi-Fi (Remove and Replace)

Correction code 21330102 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. LH 및 RH 사이드 레일 트림을 탈거합니다. Trim - Side Rail - LH (Remove and Install)을(를) 참조하십시오.
  2. LH 및 RH 후크 커버를 연 다음 나사 커버를 LH 및 RH 코트 후크에 고정하는 클립을 분리합니다.
  3. LH 및 RH 후면 코트 후크를 차량에 고정하는 나사를 탈거합니다.
    2.5 Nm (1.8 lbs-ft)
  4. LH 및 RH 상단 B필러 트림을 차량에 고정하는 클립을 분리한 다음 B필러 트림을 한쪽으로 치워둡니다. Trim - B-Pillar - Upper - LH (Remove and Replace)을(를) 참조하십시오.
    Informational PurposesAn informational icon, calling your attention
    참고
    차량에서 상단 B필러 트림을 완전히 탈거할 필요는 없습니다. 안전벨트에 아직 고정된 상태로 트림을 한쪽으로 치워둡니다.
  5. 헤드라이너의 후면 끝단을 차량에 고정하는 클립(4개)을 분리한 다음 추가 간격을 확보하기 위해 헤드라이너와 차체 사이에 접은 헝겊을 삽입합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    헤드라이너를 구부리지 않도록 주의하십시오.
  6. Wi-Fi 안테나에서 전기 커넥터를 연결 해제합니다.
  7. Wi-Fi 안테나를 차체에 고정하는 클립을 분리한 다음 차량에서 안테나를 탈거합니다.

Install

Installation procedure is the reverse of removal.