2021-12-26

Harness - Airbag - Driver (Remove and Replace)

Correction code 20013102 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Disconnect the 12V/LV battery and the First Responder Loop. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see 에어백 및 안전보조장치(SRS) 사전 주의 사항.
Warning IconA warning icon, calling your attention to a possibly risky situation
경고
안전보조장치(SRS) 구성품을 올바르게 취급하지 않으면 위험할 수 있습니다. 에어백 및 안전보조장치(SRS) 사전 주의 사항을(를) 참조하십시오.

Remove

  1. 운전석 에어백을 탈거합니다. Airbag - Driver (Remove and Replace)을(를) 참조하십시오.
  2. 운전자 방향으로 향하는 에어백 쪽을 보호 테이프로 완전히 덮습니다.
  3. 운전석 에어백을 깨끗한 작업 면에 배치합니다.
  4. 운전석 에어백 하네스를 에어백을 고정하는 잠금 탭(3개)을 분리합니다.
  5. 운전석 에어백에서 전기 하네스 커넥터(3개)를 연결 해제합니다.

Install

  1. 운전석 에어백 하네스 커넥터를 운전석 에어백에 연결한 다음 잠금 탭(3개)을 장착합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    3개의 커넥터는 색상으로 구분되어 있습니다. 하네스 커넥터의 색상을 에어백의 같은 색상 커넥터와 일치시킵니다.
  2. 에어백에서 보호 테이프를 제거합니다.
  3. 운전석 에어백을 장착합니다. Airbag - Driver (Remove and Replace)을(를) 참조하십시오.