Latch - Cinch - Trunk (Remove and Replace)
Correction code
11355012
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
트렁크 신치 래치를 트렁크 리드에 고정하는 볼트 |
![]() 8 Nm (5.9 lbs-ft) |
|
Reuse |
Remove
- 파워 트렁크 래치 커버를 탈거합니다. Cover - Latch - Power Trunk (Remove and Replace)을(를) 참조하십시오.
-
트렁크 신치 래치에서 전기 하네스를 연결 해제합니다.
-
트렁크 신치 래치를 트렁크 리드에 고정하는 볼트를 탈거한 다음 래치를 아래 쪽으로 밀어 탭을 연결 해제하고 래치를 탈거합니다.8 Nm (5.9 lbs-ft)Use of the following tool(s) is recommended:
- 10mm 소켓
Install
Installation procedure is the reverse of removal.