2020-12-16

Crush Can - Front Subframe - LH (Remove and Replace)

Correction code 10101602 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 1133185-00-A Skt, 3/8in Dr, XZN M14, Tri-Square

Remove

  1. 전면 엔드 캐리어를 탈거합니다. Carrier - Front End (Non-Heat Pump) (Remove and Replace)을(를) 참조하십시오.
  2. 전면 서브프레임에 LH 충돌 캔 브래킷을 고정하는 볼트를 탈거하고, 서브프레임에서 브래킷을 탈거합니다.
    53 Nm (39.1 lbs-ft)

Install

Installation procedure is the reverse of removal.