2019-08-13

Rear Lettering (Retrofit)

Correction code 12050606 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 1475764-00-A 고정구, 배지, 듀얼 모터/Perf, M3
  • 1049517-00-A 심 롤러, 실리콘, 5"

Procedure

  1. "듀얼 모터" 배지가 장착될 트렁크 구역을 이소프로필 알코올(IPA) 천으로 닦아냅니다.
  2. 배지 고정 툴을 트렁크 위 제자리에 놓고 마스킹 테이프로 고정합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    배지와 접착 표면 온도가 섭씨 15.556-43.333도 (화씨 60-120도) 사이인지 확인합니다. 추운 날씨에는 히트 건을 사용하여 설치 표면을 최적의 온도로 만듭니다.
  3. 접착 면의 배지 라이너를 제거한 다음, 기준점 구멍을 사용하여 배지 고정장치에 배지를 놓습니다.
  4. 배지 고정 장치의 창을 통해 배지를 눌러 트렁크에 부착합니다.
  5. 배지에서 투명한 전면 라이너를 제거합니다. 이때 라이너를 폐기하지는 않습니다
  6. 트렁크에서 배지 고정 장치와 마스킹 테이프를 제거합니다.
  7. 투명한 전면 라이너를 배지에 다시 부착하여 표면을 보호합니다.
  8. 실리콘 심 롤러로 배지를 완전히 밀착시킵니다.
  9. 배지에서 투명한 전면 라이너를 제거합니다.