2024-09-16

휠 폐기(재작업)

교정 코드 34015007 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure.NOTE: See 인체공학적 주의 사항for safe and healthy working practices.

Informational PurposesAn informational icon, calling your attention
참고
이 절차는 어떤 이유로든 교체된 휠을 재사용할 수 없도록 하기 위해 수행됩니다.
Warning IconA warning icon, calling your attention to a possibly risky situation
경고
Wear appropriate personal protective equipment (PPE) including cut-resistant gloves and safety glasses when performing this procedure.

절차

  1. 휠을 밸브 구멍이 보이도록 하여 벤치에 올려 놓습니다.
  2. 밸브 구멍 중심에서 약 3cm(1.2인치)를 측정한 후 페인트 펜으로 표시합니다.
  3. 10mm 드릴 비트를 사용하여 표시한 위치에 구멍을 뚫습니다.
  4. 휠을 적절한 폐기물 배출 장소에 폐기합니다.