2023-04-20

Harness - Electronic Parking Brake (EPB) - LH (Remove and Replace)

Correction code 17102102 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications: Harness - Electronic Parking Brake (EPB) - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
LH 후면 EPB 하네스 브래킷을 LH 후면 캘리퍼에 고정하는 볼트
5 Nm (3.7 lbs-ft)
  • 10mm 소켓
  • 4인치 익스텐션
Reuse
LH 후면 EBP 하네스 브래킷을 차체에 고정하는 볼트
5 Nm (3.7 lbs-ft)
  • 10mm 소켓
Reuse

Remove

  1. 플로어 잭 및 잭 스탠드를 사용하여 차량을 들어 올려서 지지합니다. Raise Vehicle - Floor Jack (Mobile Service)을(를) 참조하십시오.
  2. LH 후륜 휠을 탈거합니다. Wheel Assembly (Remove and Install)을(를) 참조하십시오.
  3. LH 후면 휠 라이너를 차량에 고정하는 클립(3개) 및 푸시 너트를 탈거한 다음 하네스에 접근하기 위해 라이너를 들어 올립니다.
  4. 커넥터 잠금 장치를 분리한 다음 LH 전자식 주차 브레이크 캘리퍼 전기 커넥터를 분리합니다.
  5. LH 후면 EPB 하네스 브래킷을 LH 후면 캘리퍼에 고정하는 볼트를 탈거합니다.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 소켓
    • 4인치 익스텐션
  6. LH 후면 EPB 하네스 브래킷을 차체에 고정하는 볼트를 탈거합니다.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 소켓
  7. 커넥터 잠금 장치를 분리한 다음 후면 메인 차체 하네스에서 LH 후면 전자식 주차 브레이크 하네스를 연결 해제합니다.

Install

Installation procedure is the reverse of removal.