2019-08-13

Solenoid - Glove Box (Remove and Replace)

Correction code 14051102 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 글로브박스를 탈거합니다. Glove Box - With Knee Airbags (Non-Heat Pump) (Remove and Replace)을(를) 참조하십시오.
  2. 글로브 박스에서 NVH 패드를 탈거하여 폐기합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    NVH 패드는 한 번만 사용합니다.
  3. 글로브 박스 솔레노이드 전기 하네스를 글로브 박스에 고정하는 클립을 풀어줍니다.
  4. 글로브 박스 솔레노이드를 글로브 박스에 고정하는 볼트를 탈거한 다음 글로브 박스에서 솔레노이드를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    솔레노이드 플런저는 링크 로드에 직각으로 굽은 부위가 있습니다.

Install

  1. 글로브 박스 솔레노이드를 글로브 박스에 장착합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    글로브 박스 솔레노이드를 링크 로드와 정렬하고 아래로 눌러 장착합니다.
  2. 글로브 박스 솔레노이드를 글로브 박스에 고정하는 나사를 장착합니다.
    0.8 Nm (7 lbs-in)
  3. 글로브 박스 솔레노이드 전기 하네스를 글로브 박스에 고정하는 클립을 장착합니다.
  4. 글로브 박스에 새 NVH 패드를 장착합니다.
  5. 글로브박스를 장착합니다. Glove Box - With Knee Airbags (Non-Heat Pump) (Remove and Replace)을(를) 참조하십시오.