2020-12-16

Armrest - Center Console (Remove and Replace)

Correction code 15192502 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications: Armrest - Center Console (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
암레스트 힌지 핀의 캡을 센터 콘솔에 고정하는 나사
1.6 Nm (1.2 lbs-ft)
  • Torx T15 소켓
  • 4인치 익스텐션
Reuse

Remove

  1. 필요한 경우 암레스트에서 고객의 물건을 제거하고 부착합니다.
  2. 모든 창문을 내린 후, LH 및 RH 전면 시트를 앞으로 이동시킵니다.
  3. 센터콘솔 하단 후면 패널을 탈거합니다. Panel - Lower Rear - Center Console (Remove and Replace)을(를) 참조하십시오.
  4. 센터콘솔 공기 통풍구 패널을 탈거합니다. Assembly - Rear Vent - Center Console (Remove and Replace)을(를) 참조하십시오.
  5. 센터콘솔 엔드 패널을 탈거합니다. End Panel - Center Console (Remove and Replace)을(를) 참조하십시오.
  6. 암레스트 힌지 핀을 센터콘솔에 고정하는 나사를 탈거한 다음 캡을 탈거합니다.
    1.6 Nm (1.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T15 소켓
    • 4인치 익스텐션
  7. 암레스트를 연 후, 일자 드라이버를 사용해 고리에서 스프링을 분리합니다.
  8. 암레스트를 닫은 후, 망치와 핀으로 LH 쪽을 향해 가볍게 두드려 센터콘솔에서 암레스트 힌지 핀을 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    작업을 진행하기 전에 암레스트는 반드시 닫아야 합니다.
  9. 암레스트를 들어 올려 센터콘솔에서 탈거합니다.

Install

Installation procedure is the reverse of removal, except for the following:

  • 암레스트를 설치하기 전에 조였을 때 암레스트가 개방 위치에 있는지 확인합니다.
  • 암레스트 힌지 슬롯을 암레스트 피봇 홀의 탭과 정렬합니다.