2021-01-29

Trim - Sill Panel - Rear - LH (Remove and Replace)

Correction code 15180502 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 모든 도어를 엽니다.
  2. 모든 창문을 내립니다.
  3. 2열 하단 시트 쿠션을 탈거합니다. Seat Cushion - Lower - 2nd Row (Remove and Replace)을(를) 참조하십시오.
  4. 2열 하단 시트 쿠션 부분의 위에 펜더 커버와 같은 보호 커버를 배치합니다.
  5. LH 2열 시트 사이드 볼스터를 탈거합니다. Bolster - Side - Seat - 2nd Row - LH (Remove and Replace)을(를) 참조하십시오.
  6. 후면 LH 실 패널 트림 하단 모서리를 위로 당겨 후면 LH 실 패널 트림을 하단 C필러에 고정하는 클립을 분리한 다음 차량에서 실 패널 트림을 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    LH C필러에서 나머지 후면 LH 실 패널 트림 클립을 모두 탈거하고, 나중에 후면 LH 실 패널 트림을 장착하는 경우 트림에서 모든 클립을 탈거합니다.

Install

Installation procedure is the reverse of removal, except for the following:

  • 같은 후면 LH 실 패널 트림을 재사용하는 경우, 트림에 새 클립을 장착합니다.
  • 안내 탭을 슬롯에 정렬한 다음, 아래로 눌러 클립을 결합합니다.
  • 씰이 트림과 겹치도록 합니다.