Wheel Arch Liner - Front - LH (Remove and Replace)
Correction code
12010902
0.24
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
- 1133569-00-A 플라이어, 클립 탈거
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
LH 전면 휠 아치 라이너를 차량에 고정하는 볼트 |
![]() 5 Nm (3.7 lbs-ft) |
|
Reuse |
Remove
- LH 전면 휠을 탈거합니다. 참조 항목: Wheel Assembly (Remove and Install).
-
볼트를 탈거하고 LH 전면 휠 아치 라이너를 차량에 고정하는 클립(18개)을 푼 다음 차량에서 라이너를 탈거합니다.5 Nm (3.7 lbs-ft)참고신형 차량의 패스너 개수는 그림보다 적을 수 있습니다.참고Use of the following tool(s) is recommended:
- 10mm 소켓
- 4인치 익스텐션
Install
Installation procedure is the reverse of removal.