Seal - Axle - Rear Drive Unit - LH (Remove and Replace)
Correction code
40301002
0.90
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
- 2023-11-07: 장착 섹션의 마지막 단계에서 어떤 유형의 얼라인먼트가 필요한지 정의한 얼라인먼트 요구 사항 표를 참조하도록 수정했습니다.
- 1454928-00-A공구, 실 풀러, 조절 가능, MS/MX/M3
- 1131206-00-A 장착 공구, 출력 씰, Model 3
Remove
- LH 후륜 구동장치 하프샤프트를 탈거합니다. 참조 항목: Halfshaft - Rear Drive Unit - LH (Remove and Replace).
-
조절 가능한 실 풀러 공구를 사용하여 LH 출력 실을 후륜 구동장치에서 탈거합니다.
Install
-
실 장착용 공구를 사용하여 새로운 실을 후륜 구동장치에 장착합니다.
참고실 장착용 공구를 골고루 가볍게 두드려 새 실을 장착합니다. 실이 후륜 구동장치 금형과 완전히 편평한지 확인합니다
- LH 후륜 구동장치 하프샤프트를 장착합니다. 참조 항목: Halfshaft - Rear Drive Unit - LH (Remove and Replace).
- Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust correction code as a separate activity to the SV. See 얼라인먼트 요구 사항 - 서스펜션.