Filler Neck - Reservoir - Windshield Washer (RHD) (Remove and Replace)
Correction code
17503102
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
-
필러 넥을 후드 내 보관 유닛에 고정하는 볼트를 탈거합니다.5 Nm (3.7 lbs-ft)
-
전기 하네스를 필러 넥에 고정하는 클립을 분리합니다.
- 필러 넥을 똑바로 잡아당겨 윈드실드 워셔액 저장탱크에서 탈거합니다.
Install
Installation procedure is the reverse of removal, except for the following:
- 새 필러 넥에 O-링이 장착되어 있는지 확인합니다. O-링이 장착되어 있지 않으면 장착합니다.