2025-09-11

Skid Plate - HV Battery - Front (Remove and Replace)

Correction code 16102002 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2025-07-01: e-코팅이 없는 스키드 플레이트에 대한 토크 규격을 추가했습니다.

Remove

  1. 전면 에어로 실드를 탈거합니다. Panel - Aero Shield - Front (Remove and Replace)을(를) 참조하십시오.
  2. 스키드 플레이트를 배터리에 고정하는 볼트 및 클립을 분리한 후, 배터리에서 플레이트를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    스키드 플레이트는 두 가지가 있으며, 각각 패스너 토크 규격이 다릅니다.
    검은색 스키드 플레이트(e-코팅 있음)
    13 Nm (9.6 lbs-ft)
    실버 스키드 플레이트(e-코팅 없음)
    17 Nm (12.5 lbs-ft)

Install

Installation procedure is the reverse of removal.