2022-04-24

Actuator - Latch - Hood - Primary (Remove and Replace)

Correction code 11355202 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

Informational PurposesAn informational icon, calling your attention
참고
후드 래치가 전자적으로 열리지 않으면 수동 전면 트렁크 도구를 사용하여 후드를 엽니다. 자세한 내용은 1130534-00-A 도구 프로필을 참조하십시오.
  1. 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
  2. 실내 흡기 덕트를 탈거합니다. 덕트 - 상단 - 실내 흡기(탈거 및 교체)을(를) 참조하십시오.
  3. 후드 래치 커버를 탈거합니다. Cover - Hood Latch (Remove and Replace)을(를) 참조하십시오.
  4. 후드 내 보관 유닛을 탈거합니다. Underhood Storage Unit (Remove and Replace)을(를) 참조하십시오.
  5. 후드 래치에서 기본 후드 래치 액추에이터 케이블을 분리합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    후드 래치 암에서 기본 래치 액추에이터 케이블을 탈거하기 전에 클립을 분리합니다.
  6. 기본 후드 래치 액추에이터 커넥터에서 전기 하네스를 연결 해제합니다.
  7. 차체에 기본 후드 래치 액추에이터 전기 커넥터를 고정하는 클립을 분리합니다.
  8. 전면 엔드 캐리어에 기본 후드 래치 액추에이터를 고정하는 볼트를 탈거하고 차량에서 액추에이터를 탈거합니다.
    5 Nm (3.7 lbs-ft)

Install

Installation procedure is the reverse of removal.