Fascia - Rear - Upper (Remove and Replace)
Correction code
10012802
0.72
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
후면 디퓨저를 내측 후면 페시아에 고정하는 볼트 |
![]() 3 Nm (2.2 lbs-ft) |
|
Reuse | |
하단 후면 페시아를 상단 후면 페시아에 고정하는 볼트 |
![]() 3 Nm (2.2 lbs-ft) |
|
Reuse |
Remove
- 후면 페시아를 탈거합니다. 참조 항목: Fascia - Rear (Remove and Install).
- 후면 주차 거리 센서를 탈거합니다. 참조 항목: Sensor - Parking Distance - Inner - Rear (Remove and Replace).
-
LH 및 RH 후면 리플렉터를 후면 페시아에 고정하는 탭을 분리한 다음 페시아에서 리플렉터를 탈거합니다.
-
후면 디퓨저를 후면 페시아의 내부에 고정하는 볼트를 탈거합니다.3 Nm (2.2 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10mm 소켓
- 6인치 익스텐션
그림 1. 내부 그림 2. 외부 -
각 측면에서부터 후면 페시아에 디퓨저를 고정하는 클립(10개)를 분리한 후, 후면 페시아에서 디퓨저를 탈거합니다.
-
하단 후면 페시아를 상단 후면 페시아에 고정하는 볼트를 탈거합니다.3 Nm (2.2 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10mm 소켓
-
각 측면에서부터 상단 후면 페시아를 하단 후면 페시아에 고정하는 클립을 분리한 후, 상단 후면 페시아를 하단 후면 페시아에서 분리합니다.
Install
Installation procedure is the reverse of removal.