2021-12-26

Sensor - Impact Accelerometer - B-Pillar - LH (Remove and Replace)

Correction code 20200502 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Disconnect the 12V/LV battery and the First Responder Loop. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see 에어백 및 안전보조장치(SRS) 사전 주의 사항.

Remove

  1. LH 전면 및 후면 도어를 열어 걸쇠로 고정합니다.
  2. LH 전면 및 후면 창문을 완전히 내립니다.
  3. LH 계기판 엔드캡을 탈거합니다. End Cap - Instrument Panel - LH (Remove and Replace)을(를) 참조하십시오.
  4. LH 중간 A필러 트림을 탈거합니다. Trim - A-Pillar - Middle - LH (Remove and Replace)을(를) 참조하십시오.
  5. LH 하단 A필러 트림을 탈거합니다. Trim - A-Pillar - Lower - LH (Remove and Replace)을(를) 참조하십시오.
  6. 운전석을 완전히 전방으로 이동합니다.
  7. 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
  8. 12V 전원을 연결 해제합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    12V 전원을 연결 해제한 후 B필러 가속도계를 연결 해제하기 전에 2분 이상 지났는지 확인합니다.
  9. LH 2열 시트 사이드 볼스터를 탈거합니다. Bolster - Side - Seat - 2nd Row - LH (Remove and Replace)을(를) 참조하십시오.
  10. LH 하단 C필러 트림을 탈거합니다. GUID-DB75BFBB-980C-4767-844D-DD5FC4AEE1F0.html을(를) 참조하십시오.
  11. LH 상단 B필러 트림을 차량에 고정하는 클립을 분리한 다음 트림을 한쪽으로 치워둡니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    LH 상단 B필러 트림 하단부를 차량 안쪽을 향해 당겨 하단 클립을 분리한 다음 트림 상단부를 당겨 남은 상단 클립을 분리합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    LH 상단 B필러 트림은 안전벨트에 여전히 고정되어 있습니다.
  12. LH 하단 B필러 트림을 탈거합니다. Trim - B-Pillar - Lower - LH (Remove and Replace)을(를) 참조하십시오.
  13. B필러 가속도계에서 전기 커넥터를 연결 해제합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    커넥터에 빨간색 잠금 탭이 있는 경우 커넥터에서 해당 탭을 당겨 뺀 다음 커넥터를 연결 해제합니다.
  14. B필러 가속도계를 차체에 고정하는 볼트를 탈거한 다음 차량에서 가속도계를 탈거합니다.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 소켓
    • ¼인치 표준 래칫

Install

Installation procedure is the reverse of removal, except for the following:

상단 B필러 트림을 다시 장착하려면 다음 단계를 수행합니다.
  • 차체 측 B필러가 상단 B필러 트림의 안전벨트 개구부와 정렬되도록 안전벨트 슬라이더를 조정합니다.
  • 상단 B필러 트림의 상단 가장자리를 헤드라이너 아래에 삽입합니다.
  • 상단 B필러 트림이 하단 B필러 트림과 정렬되었는지 확인합니다.
  • 전면 및 후면 도어 씰이 상단 B필러 트림과 겹치는지 확인합니다.