Shroud - Latch - Door - Rear - LH (Remove and Replace)
    
    
    
    Correction code
    
                                    11353732
                                    0.30
                                    
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
      
  
Remove
- Open the LH front door and lower the front windows.
 - Remove the LH rear door trim lower garnish. See Garnish - Lower - Door Trim - Rear - LH (Remove and Replace).
 - Remove the LH rear door trim decor. See Decor - Trim - Rear Door - LH (Remove and Replace).
 - Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
 - Set the LH rear door at a comfortable working height.
 - 
          Remove the bolts (x4) that attach the
            LH rear door speaker to the door assembly, disconnect the harness electrical connector,
            and then remove the speaker assembly from the vehicle.
4 Nm (2.9 lbs-ft)TIpUse of the following tool(s) is recommended:- T25 socket
 
 - 
          Release the tabs (x2) that attach the
            LH rear door latch shroud to the vehicle, and then remove the shroud from the
            vehicle.
          
 
Install
- 
          Position the LH rear door latch shroud into the vehicle, and then secure the tabs
            (x2) that attach the shroud to the vehicle.
          
 - 
          Position the LH rear door speaker into
            the door assembly, connect the harness electrical connector, and then install the bolts
            (x4) that attach the speaker assembly to the vehicle.
4 Nm (2.9 lbs-ft)TIpUse of the following tool(s) is recommended:- T25 socket
 
 - Install the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
 - Install the LH rear door trim decor. See Decor - Trim - Rear Door - LH (Remove and Replace).
 - Install the LH rear door trim lower garnish. See Garnish - Lower - Door Trim - Rear - LH (Remove and Replace).
 - Raise the front windows and close the LH front door.