2024-12-02

TPMS (Sensor ID Tool Learn)

Correction code 34041100 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2024-12-02: Updated Service Mode instructions.
  • 2024-09-11: Added note with links to update TPMS Tool firmware.
  • 2023-11-01: Updated procedure and Toolbox routine.
Informational PurposesAn informational icon, calling your attention
Note
For instructions on how to update the firmware on the TPMS Wake Tool, refer to the manufacturer’s instructions. Tesla employees can refer here for the TT02 tool and here for the TT03 tool.
  1. Review the TPMS service tool profile.
  2. Connect a laptop with Toolbox to the vehicle. See Toolbox 3 (Connect and Disconnect).
  3. In Toolbox, select the Actions tab, and search for "TPMS Sensor Learn".
  4. Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): PROC_TPMS_X_TPMS-SENSOR-LEARNvia Toolbox: (link)via Service Mode Plus: Chassis ➜ TPMS ➜ Learn ID
  5. Use the TPMS service tool to read and record the wheel sensors in the order displayed on the tool's screen.
  6. Enter the TPMS sensor ID for each wheel.