2022-11-17

Cooling System (Check and Fill)

Correction code 18300200 0.40 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Procedure

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Install).
  3. Remove the coolant bottle cap.
  4. Use an inspection mirror to make sure that the coolant level is at the Max line, and top off if necessary.
  5. Install the coolant bottle cap.
  6. Install the underhood storage unit. See Underhood Storage Unit (Remove and Install).
  7. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).