2022-06-17

Thermal Fluid - Cooling System (Fill/Drain)

Correction code NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
Informational PurposesAn informational icon, calling your attention
Note
This procedure is performed in conjuction with certain component replacement procedures. This is not a standalone procedure.

Procedure

  1. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  2. In Toolbox 3, click the Actions/Autodiag tab, and type 'Thermal' into the search field.
  3. Click Start Thermal Fluid Fill/Drain (Coolant Only), click Run, and allow the routine to complete.
  4. Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3 (Connect and Disconnect).
  5. Return to the procedure that requested a thermal fluid fill drain.