2025-01-28

Wiper Arm - LH (Remove and Replace)

Correction code 17500302 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2025-01-28: Corrected torque value for wiper arm nut from 32 Nm to 25 Nm.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Release the LH wiper arm hose nozzle.
  4. Remove the LH wiper arm nut cover.
  5. Remove the nut that attaches the LH wiper arm to the vehicle, and then use a wiper arm removal tool to remove the wiper arm from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not flex the wiper arm to remove it.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lower the hood slightly to fit the wiper arm removal tool.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm socket
    • Wiper Arm Removal Tool - 1058696-00-A

Install

  1. Position the LH wiper arm into the vehicle, and then install the nut that attaches the wiper arm to the vehicle.
    25 Nm (18.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm socket
  2. Install the LH wiper arm nut cover.
  3. Attach the LH wiper arm hose nozzle.
  4. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  5. Raise the LH front window and close the LH front door.