2022-08-08

Floor Panel - Mid - 2nd Row (5 Seat) (Remove and Replace)

Correction code 15303052 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  2. Remove the 2nd row floor mat.
  3. With assistance, release the clips (x5) that attach the 2nd row mid floor panel to the vehicle, and then remove the floor panel from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Tilt the front edge upwards and remove in vertical position.

Install

  1. With assistance, position the 2nd row mid floor panel into the vehicle, and then secure the clips (x5) that attach the floor panel to the vehicle.
  2. Install the 2nd row floor mat.
  3. Install the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).