2024-12-02

TPMS (Sensor ID Drive Learn)

Correction code 34041150 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2024-12-02: Updated Service Mode instructions.

Procedure

  1. Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): PROC_VCSEC_X_TPMS-ERASE-SENSOR-IDvia Toolbox: (link)via Service Mode: Chassis ➜ TPMS ➜ Erase All TPMS IDs PROC_VCSEC_X_TPMS-ERASE-AND-AUTOLEARNvia Toolbox: (link)
    Informational PurposesAn informational icon, calling your attention
    Note
    This action erases stored TPMS Sensor IDs.
  2. Drive the vehicle a short distance to verify all four TMPS sensor values are displaying on the touchscreen.
    Informational PurposesAn informational icon, calling your attention
    Note
    The sensors will begin displaying values at approximately 5 mph. When vehicle receives communication from the sensors with known IDs, It will quickly connect to them. If tire pressures do not populate, rescan each sensor and try again.