2025-03-23

LV Battery - Recover (Restore)

Code de correction 17010008 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure.

Informational PurposesAn informational icon, calling your attention
Remarque
The LV battery won't recover unless the HV system is healthy and supporting the vehicle. Make sure that the HV system is functioning correctly before attempting to recover the LV battery .
  1. Remove the rear underhood apron. See Tablier sous le capot - arrière (retirez et remplacez).
  2. Disconnect the LV battery connector and keep the first responder loop connected.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Release the green locking tab, pull the black connector lock outwards to release the connector, and then pull up to disconnect the connector.
  3. Connect the LV maintainer.
    1. Release the positive jump post cover.
    2. Attach the positive LV maintainer clamp to the positive jump post.
    3. Attach the negative LV maintainer clamp to the bolt head located between the brake fluid reservoir and the front trunk.
    4. Connect the LV maintainer to a power supply and switch it on.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    ATTENTION
    To avoid damaging the vehicle, DO NOT allow the positive terminal to make contact with any other metal components than the positive jump post.
  4. Connect the LV battery connector.
    Seat the LV battery connector on the LV battery, push the black connector lock inwards to engage the connector, and then seat the green locking tab after the lock is fully secured.
  5. Open LH front door and lower the window.
  6. Enable Service Mode. See Mode Entretien.
  7. Disconnect the LV maintainer.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Power off the LV maintainer and release the connections from the vehicle. Reinstall the positive jump post cover.
  8. Vérifiez l'état de la batterie BT.
    • Si après 2 minutes de soutien PCS, l'alerte VCFRONT_a478_LVBMS_MOSFET_Open est présente, la récupération automatique de la batterie BT ne s'est pas effectuée. La récupération automatique peut être tentée manuellement par le biais de l'écran tactile ou de Toolbox, comme indiqué à l'étape suivante.
  9. Exécutez la routine suivante au moyen du mode Entretien ou de Toolbox (consultez 0005 – Modes d’entretien) : PROC_VCFRONT_X_RECONNECT-LV-BATTERYvia Toolbox: (link)via Service Mode: Low Voltage ➜ Power Distribution ➜ Close MOSFET
  10. Si les étapes ci-dessus ne permettent pas de récupérer automatiquement la batterie BT, récupérez la batterie à l'aide du chargeur de batterie Tesla Li-Ion.
    • Assurez-vous qu'un déchargement à courant élevé n'a pas lieu et que la batterie ne se protège pas elle-même.
    • Allez à Mode Entretien > Basse tension > Distribution d'alimentation > Batterie BT et vérifiez que l'état de charge (SoC) de la batterie BT augmente.
    • Vérifiez que l'état MOSFET de la batterie BT est Fermé.
  11. Exit Service Mode. See Mode Entretien.
  12. Install the rear underhood apron. See Tablier sous le capot - arrière (retirez et remplacez).