2023-03-02
Garniture - montant arrière - inférieure - gauche (7 sièges) (retirez et remplacez)
Code de correction
15180522 0.06 NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when
performing the below procedure.
Retirer
- Open the LH doors and lower all the windows.
- Move the driver seat fully forward.
- Slide and tilt the LH 2nd row seat fully forward.
- Partially remove the lower portion of the LH rear door seal.
-
Release the clips (x8) that attach the LH lower C-pillar trim to the vehicle, and
then remove the trim from the vehicle.
RemarqueThe rear edge is mated with a groove in the trunk side trim.RemarqueRelease the clips at the front of the LH rear sill trim, and then work towards the rear of sill trim.
Installer
-
Position the LH lower C-pillar trim to
the vehicle, and then install the clips (x8) that attach the trim to the vehicle.
RemarqueThe rear edge is mated with a groove in the trunk side trim.
-
Reseat the LH rear door seal.
RemarqueSeat the pillar and sill trim tabs underneath the seal.
- Move the LH 2nd row seat to the original position.
- Move the driver seat to the original position.
- Raise all the windows and close the LH doors.