2024-06-17
Glissière d'écoulement - Ordinateur de bord (HW4) (Retrait et remplacement)
Code de correction 2110022012 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure.
Retirer
- Remove the RH instrument panel end cap. See Capuchons d’extrémité - tableau de bord - gauche (retirez et remplacez).
- Remove the RH mid A-pillar assembly. See Garniture - montant avant - milieu - gauche (retirez et remplacez).
- Remove the RH lower A-pillar trim. See Garniture - montant avant - inférieure - gauche (retirez et remplacez).
- Remove the RH footwell cover. See Couvercle - espace pour les jambes - passager (conduite à gauche) (retirez et remplacez).
- Remove the main instrument panel decor trim. See Garniture décorative - tableau de bord - principal (retirez et remplacez).
- Remove the glove box. See Boîte à gants - sans coussins gonflables pour les genoux (retirez et remplacez).
-
Release the tabs (x3), and then remove the drip guard assembly from the
vehicle.
NotePull on the drip guard assembly, then tilt it in front of the car computer to remove it.
Installer
La procédure d’installation se fait en suivant l’ordre inverse de la procédure de retrait.