2023-01-26
Prise de courant 12 V - coffre arrière (retirez et remplacez)
Code de correction
17303202 0.12 NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when
performing the below procedure.
N/A
Retirer
- Open the liftgate.
- Open the LH front door.
- Disconnect 12V/LV power. See Alimentation 12 V/BT (déconnectez et connectez).
-
Release the clips (x4) that attach the top edge of the LH trunk side trim to the vehicle, and then carefully pull back the top edge of the trim.
TIpNous recommandons l’utilisation des outils suivants :
- Plastic trim tool
-
Disconnect the rear trunk power socket 12V connector.
ATTENTIONAvoid pulling the connector wiring. Press and pull to release the connector.
-
Release the rear trunk power socket 12V connector from the LH trunk side trim.
RemarquePull the connector upwards until it clears the mounting tab.
-
Gently push the rear trunk power socket 12V forward, while simultaneously pulling the upper and lower mount tabs outward to release the power socket 12V from the LH trunk side trim, and then remove the power socket 12V from the vehicle.
TIpNous recommandons l’utilisation des outils suivants :
- Pic à prise souple, embout à 90 degrés, 6 po
Installer
-
Position the rear trunk power socket 12V on the vehicle, insert the connector first, followed by the mount, and then the power socket 12V outlet. Gently push the outlet with the cover facing upwards to secure in place.
RemarqueEnsure proper fitment of the power socket 12V.
-
Install the rear trunk power socket 12V connector on the LH trunk side trim.
RemarquePush the connector downwards until fully lowered on the mounting tab.
- Connect the rear trunk power socket 12V connector.
-
Install the clips (x4) that attach the top edge of the LH trunk side trim to the vehicle.
RemarqueReplace clips as necessary. Attach the clip closest to rear seat back first, and then work towards the liftgate.
- Connect 12V/LV power. See Alimentation 12 V/BT (déconnectez et connectez).
- Close the liftgate.
- Close the LH front door.