2023-05-19
Bride - plaque d’immatriculation - arrière (ND) (retirez et remplacez)
Code de correction
12072312 0.06 NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when
performing the below procedure.
Retirer
Installer
-
Inspect and clean the install area on
liftgate.
RemarqueVerify that thread inserts were not damaged during removal, and clean off the surface area from any dirt and debris.
-
Position the rear license plate bracket to the liftgate, and then install the screws
(x2) that attach the bracket to the liftgate.1.2 Nm (.9 lbs-ft)TIpNous recommandons l’utilisation des outils suivants :
- Douille Torx T20