Model Y Service Manual

2105 – Écran tactile

Panneau de service - tableau de bord (retirez et remplacez)
Code de correction 21051212 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure.
Écran tactile (retirez et remplacez)
Code de correction 21051202 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure.

Sujet parent : 21 – Infodivertissement

Manuel d'entretien Model Y
Notes de mise à jour
Renseignements généraux
00 – Inspection et entretien
10 – Carrosserie
11 – Fermetures
12 – Accessoires extérieurs
13 – Sièges
14 – Tableau de bord
- Caractéristiques techniques de couple – Tableau de bord
- 1405 – Tableau de bord
15 – Garniture intérieure
16 – Système de batterie
17 – Système électrique
18 – Gestion thermique
20 – Sécurité et systèmes de retenue
21 – Infodivertissement
30 – Châssis
- Caractéristiques techniques de couple – Châssis
- 3001 – Châssis et châssis auxiliaires
31 – Suspension
32 – Direction
33 – Freins
34 – Roue et pneus
39 – Unité d’entraînement avant
40 – Unité d’entraînement arrière
44 – Système haute tension
50 – Connecteurs de chargement externes
- 5001 – Connecteur mobile
  - Mise à jour du micrologiciel - Connecteur mobile
  - Retirer l’écran isolant - poignée de recharge
- 5003 - Adaptateurs de recharge
  - Mise à jour de micrologiciel - adaptateur de recharge CHAdeMO

Torque Calculator Values

T1 (Original torque spec)

L (Distance from center of wrench grip to center of square drive tang)

E (Horizontal distance from center of square drive tang to center of fastener)

Note

If the angle from the extension to the torque wrench is greater than 90° (Figure 2), input E as a positive number.
If the angle from the extension to the torque wrench is less than 90° (Figure 3), input E as a negative number.
If the angle from the extension to the torque wrench is exactly 90°, this calculator is not needed. Torque the fastener to T1.

T2 (Final torque setting)