2023-05-19

Nettoyez le moteur du ventilateur

Code de correction 18103205 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure.

Procédure

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear underhood apron. See Tablier sous le capot - arrière (retirez et remplacez).
  3. Remove the underhood storage unit. See Unité de rangement sous le capot (retirez et remplacez).
  4. Remove the fresh air intake duct. See Conduit - admission d’air frais (retirez et remplacez).
  5. Cycle the HVAC on/off to open the HVAC duct.
  6. Use a blow gun to blow shop air into the HVAC module assembly to remove dust particles from the blower motor blades.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Remove any loose debris from fresh air inlet seal before using blow gun.
  7. Remove and replace the cabin filter. See Filtre - habitacle (retirez et remplacez).
  8. Install the fresh air intake duct. See Conduit - admission d’air frais (retirez et remplacez).
  9. Install the underhood storage unit. See Unité de rangement sous le capot (retirez et remplacez).
  10. Install the rear underhood apron. See Tablier sous le capot - arrière (retirez et remplacez).
  11. Raise the LH front window and close the LH front door.