2024-11-21

Joint – hayon – coté – gauche (retrait et remplacement)

Code de correction 11709202 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure.

Retirer

  1. Ouvrez le hayon.
  2. Retirez le joint d’étanchéité du hayon latéral gauche du hayon et jetez-le.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Jetez le joint, car il ne peut pas être réutilisé.
  3. Retirez tout adhésif restant et nettoyez la surface avec des lingettes à l’alcool isopropylique.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Laissez sécher pendant 1 minute.

Installer

  1. Utilisez du ruban à masquer pour effectuer un montage à sec du joint d’étanchéité du côté gauche du hayon.
  2. Si le véhicule était construit à Fremont, Austin ou Berlin, utilisez un marqueur pour tracer une ligne sur l’extrémité saillante du joint, puis coupez le joint à la bonne longueur à l’aide de ciseaux.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Les véhicules construits en Chine n’ont pas besoin d’adaptation.
  3. Retirez l’endos adhésif, puis installez le joint d’étanchéité du côté gauche du hayon dans le hayon.
  4. Retirez tout ruban de masquage résiduel du hayon.
  5. Fermez le hayon.