2024-06-03

Garniture de dissimulation d’interstice - colonne de direction - inférieur (retirez et remplacez)

Code de correction 14050022 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure.

Retirer

  1. Open the LH front door and fully lower the window.
  2. Remove the rear underhood apron. See Tablier sous le capot - arrière (retirez et remplacez).
  3. Disconnect 12V power. See Alimentation 12 V/BT (déconnectez et connectez).
  4. Remove the driver airbag. See Coussin gonflable - conducteur (retirez et remplacez).
  5. Remove the steering wheel. See Volant (retirez et installez).
  6. Remove the steering column upper shroud. See Carénage - supérieur - colonne de direction (retirez et remplacez)
  7. Remove the steering column lower shroud. See Carénage - inférieur - colonne de direction (retirez et remplacez)
  8. Remove the LH footwell cover. See Couvercle - espace pour les jambes - conducteur (retirez et remplacez).
  9. Remove the driver knee airbag. See Coussin gonflable - genou - conducteur (retirez et installez).
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Knee airbags are only installed on vehicles for US market.
  10. Release the clips that attach the lower steering column gap hider from the instrument panel sub assembly.
  11. Remove the lower steering column gap hider from the vehicle.

Installer

La procédure d’installation se fait en suivant l’ordre inverse de la procédure de retrait.