2025-03-10

Boîte à gants - sans coussins gonflables pour les genoux (retirez et remplacez)

Code de correction 14051012 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure.

  • 2023-10-06: Updated USB cable disconnection step.

Retirer

  1. Remove and secure the customer's belongings from the glove box, if needed.
  2. Remove the LH and RH instrument panel end caps. See Capuchons d’extrémité - tableau de bord - gauche (retirez et remplacez).
  3. Remove the LH and RH air wave end caps. See Capuchons d’extrémité - onde d’air - gauche (retirez et remplacez).
  4. Remove the RH middle A-pillar trim. See Garniture - montant avant - milieu - gauche (retirez et remplacez).
  5. Remove the RH lower A-pillar trim. See Garniture - montant avant - inférieure - gauche (retirez et remplacez).
  6. Remove the passenger footwell cover. See Couvercle - espace pour les jambes - passager (conduite à gauche) (retirez et remplacez).
  7. Remove the main instrument panel decor trim. See Garniture décorative - tableau de bord - principal (retirez et remplacez).
  8. Open the glove box.
  9. For HW4 vehicles, release the clip that attaches the glove box to the RH air vent.
  10. Push down on the metal locking tab of the USB connector, and then disconnect the glove box USB cable from the car computer.
  11. Remove the screws that attach the glove box to the IP carrier.
    Informational PurposesAn informational icon, calling your attention
    Note
    One screw may be inside the glove box and not visible in the following image.
  12. Release the clips that attach the glove box to the IP carrier.
  13. Disconnect the electrical harness from the glove box solenoid connector, the damper connector, and the puddle light connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    2 of the electrical connectors are accessed from the bottom of the instrument panel.
  14. Remove the glove box from the vehicle.

Installer

  1. Bring the glove box into the vehicle, and then connect the electrical harness to the glove box solenoid connector, the damper connector, and the puddle light connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    2 of the electrical connectors are accessed from the bottom of the instrument panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Route the electrical harness from the puddle lamp forward of the divider at the linkages.
  2. Make sure that the glove box damper pin is fully seated, and not to bump the glove box damper when installing the glove box.
  3. Fasten the clips that attach the glove box to the IP carrier.
  4. Install the screws that attach the glove box to the IP carrier.
    2.3 Nm (1.7 lbs-ft)
  5. Connect the glove box USB cable to the car computer.
  6. For HW4 vehicles, install the clip that attaches the glove box to the RH air vent.
  7. close the glove box.
  8. Install the main instrument panel decor trim. See Garniture décorative - tableau de bord - principal (retirez et remplacez).
  9. Install the passenger footwell cover. See Couvercle - espace pour les jambes - passager (conduite à gauche) (retirez et remplacez).
  10. Install the RH lower A-pillar trim. See Garniture - montant avant - inférieure - gauche (retirez et remplacez).
  11. Install the RH middle A-pillar trim. See Garniture - montant avant - milieu - gauche (retirez et remplacez).
  12. Install the LH and RH air wave end caps. See Capuchons d’extrémité - onde d’air - gauche (retirez et remplacez).
  13. Install the LH and RH instrument panel end caps. See Capuchons d’extrémité - tableau de bord - gauche (retirez et remplacez).
  14. Verify that the glove box opens normally through the touchscreen.
  15. If removed earlier, put the customer's belongings back into the glove box.