2023-05-19

Support – rucket – gauche (retrait et remplacement)

Code de correction 15306112 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure. REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps forfaitaire ci-dessus représentent tout le travail à être fait pour cette procédure, notamment les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire. REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. Vous pouvez transmettre par courriel vos commentaires relatifs aux valeurs des temps forfaitaires à LaborTimeFeedback@tesla.com. REMARQUE : Consultez Protection individuelle pour vous assurer de porter l’équipement de protection individuelle adéquat lors vous effectuez la procédure ci-dessous.

Installer

  1. Position the LH rucket bracket into the vehicle, and then install the clips (x2) that attach the bracket to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Perform a push-pull-push test to verify the bracket is fully secure.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    The clip position should not be adjusted after bracket is removed or it will result in the bracket not seating properly. If the clip position is changed or the push-pull action shows the bracket is not secure, remove the clip from the tab, seat the clip into the doghouse on the bracket, and then reinstall.
  2. Move the trunk tub liner into the original position, and then install the push clip that attaches the liner to the rucket bracket.
  3. Install the LH load floor bracket. See Bride - plancher de chargement du coffre - gauche (retirez et remplacez).