03/06/2024 16:56:47

Phares - réglage - ND (méthode du mur)

Code de correction 17400100 0.18 REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps forfaitaire ci-dessus représentent tout le travail à être fait pour cette procédure, notamment les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire.REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. Vous pouvez transmettre par courriel vos commentaires relatifs aux valeurs des temps forfaitaires au LaborTimeFeedback@tesla.com. REMARQUE : Consultez Protection individuelle pour vous assurer de porter l’équipement de protection individuelle adéquat lors vous effectuez la procédure ci-dessous.

  • 2024-04-01: Updated measurements and units.

Identify Headlight Type

This procedure is NOT applicable to the "Global" style headlight. The global headlight (2) has a different reflector and lens design compared to the SAE/ECE headlight (1), illustrated below. For instructions on adjusting the global headlight, see Phares - réglage - global (méthode du mur).

Adjust Headlights Using a Wall

  1. Position the vehicle for adjusting the headlights. The vehicle should be:
    • Located in a darkened area.
    • Parked on a level surface.
    • Perpendicular to a wall that has a white matte surface. The wall must be at least 6 ft (1.83 m) high and 12 ft (3.76 m) wide.
  2. Make sure that all 4 tires are inflated to specification.
  3. Put a piece of tape on the wall 32 in (81.2 cm) from the ground to indicate where the beam should show.
  4. Measure 25 ft (7.62 m) away from the wall and put a piece of tape on the ground to indicate where the vehicle should be parked.
  5. Park the vehicle perpendicular to the wall so that the front fascia is flush with the tape that was placed on the ground in the previous step.
  6. On the vehicle touchscreen, touch Controls > Service > Adjust Headlamps to enable Headlight Adjustment Mode.
  7. Cover the RH headlight; make sure that all light from the right headlight is blocked.
  8. On the vehicle touchscreen, select Left, then use the left scroll wheel on the steering wheel to adjust the beam level.
    Informational PurposesAn informational icon, calling your attention
    Note
    The top right part of the beam should align with the tape mark on the wall
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not sit in the vehicle, as this will affect headlight alignment.
  9. Remove the cover from the RH headlight.
  10. Repeat step 7 through step 9 covering the LH headlight and adjusting the RH headlight.
  11. Exit the headlight adjustment mode on the center display.