2025-03-10

Ruban NVH – Plaquettes de frein – Avant (Europe, Moyen-Orient et Afrique) (adaptation)

Code de correction 33010706 0.20 REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps forfaitaire ci-dessus représentent tout le travail à être fait pour cette procédure, notamment les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire.REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. Vous pouvez transmettre par courriel vos commentaires relatifs aux valeurs des temps forfaitaires au LaborTimeFeedback@tesla.com. REMARQUE : Consultez Protection individuelle pour vous assurer de porter l’équipement de protection individuelle adéquat lors vous effectuez la procédure ci-dessous.

  • 2025-03-03: Updated notes.
  • 2024-07-15: Updated procedure for pre-cut stickers and added region information.
  • 2024-06-25: Updated notes.
  • 1994754-00-A STICKER FOR CALIPER
  • 1021050-00-A PRIMER, TAPE, 3M, No. 94

Procédure

Informational PurposesAn informational icon, calling your attention
Note
This is an additional procedure, to prevent NVH issues. This procedure is only applicable to the EMEA market.
Informational PurposesAn informational icon, calling your attention
Note
Add this correction code as an extra activity to the service visit, combined with the correction code for Brake Pads (Remove and Install or Remove and Replace).
  1. Clean the back side of the front brake pads (x4) and the surfaces of the brake caliper pistons (x8) using brake cleaner.
  2. Apply primer to the back side of the front brake pads (x4), and then allow 5 minutes to dry.
  3. Align the pre-cut NVH sticker to the back side of the front brake pads (x4), and then apply pressure on the stickers to adhere them to the brake pads.
  4. Remove the protective cover from the NVH sticker applied to the brake pads (x4).
  5. Clean the brake caliper retaining pins (x4) using a hand brush and soapy water, and then apply an even layer of Silaramic lubricant to the brake caliper retaining pins.
  6. Proceed with the installation of the front brake pads.