2026-07-16

Mainteneur BT (connecter et déconnecter)

Code de correction 17010500 0.06 REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps forfaitaire ci-dessus représentent tout le travail à être fait pour cette procédure, notamment les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire. REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. REMARQUE : Consultez Protection individuelle pour vous assurer de porter l’équipement de protection individuelle adéquat lors vous effectuez la procédure ci-dessous. REMARQUE : Voir Précautions ergonomiques pour consulter les pratiques de travail sécuritaires et saines.

  • 2026-07-07: Deleted steps to disconnect/connect the 12V/LV battery.
  • 2025-12-05: Added a caution to make sure windows are not moved for at least 1 minute before disconnecting the LV maintainer.
  • 2023-10-31: Updated the location to attach the maintainer's negative clamp with new images attached.
Warning IconA warning icon, calling your attention to a possibly risky situation
ATTENTION
Avant de débrancher le mainteneur BT, assurez-vous que les fenêtres ne soient pas déplacées pendant au moins 1 minute. Si vous n'attendez pas avant de débrancher, vous pourriez endommager les composants.

Connecter

  1. Enable Service Mode. See Mode Entretien.
  2. Release the positive terminal cover.
  3. Secure the LV maintainer positive terminal to the jump post.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    ATTENTION
    To avoid damaging the vehicle, DO NOT allow the positive cable to make contact with other metal components.
  4. Secure the LV maintainer negative terminal to the bolt located between the brake fluid reservoir and front trunk.
  5. Connect the LV maintainer to a power supply, and then power on.

Disconnect

  1. Power off the LV maintainer.
  2. Release the negative terminal connection from the vehicle first, and then release the positive terminal.
  3. Install the positive terminal cover.
  4. Confirm that the LV battery State Of Charge (SOC) is above 73% and Battery State is Charge or Standby.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    If the LV battery SOC is below 73% confirm that Battery State is Charge and Pack Current is positive, Via Tesla Garage > LV.