2024-11-01
Vue dégagée de la caméra avant (nettoyage de précision du pare-brise intérieur)
Code de correction
10200348 0.24 NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when
performing the below procedure.
- 24-10-2024 : Ajout d'une vidéo démontrant le nettoyage de précision du pare-brise.
- 27-08-2024 : Ajout d'une étape pour nettoyer les balais d'essuie-glace.
- 02-07-2024 : Mise à jour des numéros de pièce d'outil.
- 2024-06-13 : Mise à jour de la méthode d'inspection et des schémas et ajout de la liste d'outils.
- 07-03-2024 : Ajout d'instructions détaillées sur la façon de nettoyer le pare-brise et ajout d'étapes d'inspection par caméra après le nettoyage.
- 19-03-2024 : Ajout d'étapes de réinitialisation DAS.
- Glass Cleaner:
- 1083742-02-A - Zep glass cleaner (preferred if available in your region)
- Invisible Glass - Premium Glass Cleaner
- Wurth Glass Cleaner (for China: 2092858-00-A)
- Lint free Microfiber towels:
- 2084223-00-A - 6 pack
- 2084180-00-A - 120 pack
- For China: 2092859-00-A
- If the above part numbers are not available in your region, use other New, Lint Free microfiber towels.
- LED flashlight:
- 1523885-00-A - LIGHT, PEN STYLE, RECHARGEABLE
Remarque
La vidéo suivante montre le nettoyage de précision du pare-brise pour tous les véhicules :
Procédure
-
Gently lift the wiper arms away from the
windshield to access the wiper blades, and then clean the wiper blades (x2) with isopropyl
(rubbing) alcohol, especially the edge of the wiper blades.
ATTENTIONIf wiper blades show degradation and need to be replaced, recommend customers to replace the wiper blades to prevent reduced camera visibility performance.ATTENTIONDo not lift a wiper arm beyond its intended position.RemarqueRemind customers to periodically clean the edge of the wiper blades as instructed in the Owner's Manual.
- Apply glass cleaner onto a microfiber towel to clean the outside surface of the front windshield, then use a second dry microfiber towel to wipe the windshield in a circular motion until the windshield is basically dry. Verify the windshield has no stains or residue, then allow 1 minute to fully dry.
-
Use an LED flashlight to illuminate the
outside surface of the windshield in the forward facing camera area, inspect for presence
of any haze, fogginess, stains and residue on the inside of the windshield. Hold the
flashlight towards you as shown in the images.
RemarquePerform the inspection indoors.RemarqueFlashlight should be pointing at the windshield towards you, see diagram for proper inspection method.RemarqueIf the presence of haze, smudges cannot be confirmed using the flashlight based inspection method, continue to step 3 to verify using camera preview method.RemarqueIf the presence of haze, smudges is confirmed with flashlight based inspection method, continue to step 4.
-
On the touchscreen, tap the Service Mode
"wrench" (at the bottom of the touchscreen UI), and then tap Main/Wide/Narrow tabs to preview all forward facing cameras and assess the
visual clarity.
, select
- If no residue or dirt is visible across all camera lenses, remove this code from the activity and continue diagnosis.
- If the image is blurry or the visuals are impeded, continue to clean the windshield and camera lenses.
- Ouvrez la porte avant gauche et abaissez la glace avant gauche.
- Retirez le capot de la caméra orientée vers l’avant. Voir Capot - caméra triple (retirez et remplacez).
-
Clean the inside surface of the
windshield in the forward facing camera area as follow:
- Apply glass cleaner onto a clean microfiber towel and use the towel to wipe the entire area.
- Use another dry microfiber towel to wipe the entire area.
- Inspect and verify that the entire area is free of any hazing, fogginess, stains and residue.
RemarqueClean the entire area thoroughly, including the edges and corners.RemarqueFor HW4 vehicles, pay special attention to ensure the notch is also clean (see picture for notch location).RemarqueWhile cleaning, use the camera preview feature to ensure that the towel reaches all the way up into the cavity and that the glass area directly in front of the camera is cleaned properly. -
Clean the forward facing camera lenses
as follows:
- Apply glass cleaner onto a clean microfiber towel and use the towel to wipe each lens.
- Before the lens surface dries, use a dry clean microfiber towel to clean the lens.
- Using camera preview, verify the lenses are free of any stains or residue.
- Installez le capot de la caméra orientée vers l’avant. Voir Capot - caméra triple (retirez et remplacez).
- For vehicles which are on firmware version 2024.26.X OR fsd-eap-12-4-1 or newer, continue to perform the following steps. For vehicles with earlier firmware and autopilot versions, terminate the procedure.
- Branchez localement un ordinateur portable doté du logiciel Toolbox 3 au véhicule. Voir Toolbox 3.0 (connecter et déconnecter).
- Déverrouillez la passerelle du véhicule. Voir Passerelle (déverrouiller).
-
If any camera FOV residue alert
presents, clear the alert.
- On the touchscreen, tap Run, and allow the routine to complete. , click
- Tap Reset DAS to reset the driver assistance system. Close the routine once it is successfully completed.
-
If no camera FOV residue alert presents,
tap
to record the cleaning completion.RemarqueIf the alert has been cleared previously, skip this step.
- Quitter mode Entretien. Voir Mode Entretien.
- Relevez la glace avant côté gauche et fermez la porte avant côté gauche.