Ruban NVH – Plaquettes de frein – Arrière (Europe, Moyen-Orient et Afrique) (adaptation)
Code de correction 33010806 0.24 REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps forfaitaire ci-dessus représentent tout le travail à être fait pour cette procédure, notamment les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire.REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. Vous pouvez transmettre par courriel vos commentaires relatifs aux valeurs des temps forfaitaires au LaborTimeFeedback@tesla.com. REMARQUE : Consultez Protection individuelle pour vous assurer de porter l’équipement de protection individuelle adéquat lors vous effectuez la procédure ci-dessous.
- 2025-03-03: Updated notes.
- 2024-08-05: Updated instructions to apply tape only on inner brake pads.
- 2024-07-15: Updated procedure for pre-cut stickers and added region information.
- 2024-06-25: Updated notes.
- 1994754-00-A STICKER FOR CALIPER
- 1021050-00-A PRIMER, TAPE, 3M, No. 94
Procédure
- Clean the back side of the inner rear brake pads (x2) and the surfaces of the brake caliper pistons (x2) using brake cleaner.
- Apply primer to the back side of the inner rear brake pads (x2), and then allow 5 minutes to dry.
- Cut the NVH stickers (x2) at the indicated line, to create 80 mm long stickers for the inner rear brake pads.
- Align the NVH stickers to the back side of the inner rear brake pads (x2), and then apply pressure on the pieces of NVH tape to adhere them to the brake pads.
- Remove the protective cover from the NVH stickers applied to the brake pads (x2), and then cut away the NVH stickers at the location of the holes (x2) of each brake pad.
- Proceed with the installation of the rear brake pads.