2020-12-16

Pivot Clamps - Seat Back - 2nd Row - Center/20 (Remove and Replace)

Correction code 13050402 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. 토크 규격: Pivot Clamps - Seat Back - 2nd Row - Center/20 (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
2열 중앙 시트 등받이 피벗 클램프를 차량에 고정하는 볼트
22 Nm (16.2 lbs-ft)
  • Torx T40 소켓
  • 육각 헤드 래칫/플렉스 헤드 토크 렌치
Reuse

Remove

  1. 모든 도어를 열고 모든 창문을 완전히 내립니다.
  2. 전면 시트를 가장 앞쪽 위치로 이동합니다.
  3. 중앙 2열 시트 등받이를 아래로 접습니다.
  4. 중앙 2열 헤드레스트를 완전히 올립니다.
  5. 중앙 2열 등받이 스위치를 탈거합니다. Backrest Switch – Seat Back – 2nd Row – Center (Remove and Replace)을(를) 참조하십시오.
  6. 트림 공구를 사용하여 중앙 후면 패널을 시트에 고정하는 클립을 좌석 하단에서 위쪽 방향으로 분리한 다음 시트 어셈블리에서 패널을 탈거합니다.
  7. 중앙 2열 럼버번을 탈거합니다. Lumbar Bun - 2nd Row - Center/20 (Remove and Replace)을(를) 참조하십시오.
  8. 2열 중앙 등받이 피벗 클램프를 차량에 고정하는 볼트를 탈거합니다.
    22 Nm (16.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T40 소켓
    • 육각 헤드 래칫/플렉스 헤드 토크 렌치
  9. 2열 시트 등받이 피벗 클램프를 시트 등받이의 중앙으로 민 다음 클램프를 바깥쪽으로 당겨 차량에서 탈거합니다.

Install

Installation procedure is the reverse of removal.