2021-03-22

Sensor - Position - Seat Track - 2nd Row Seat - RH (Remove and Replace)

Correction code 13022602 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. RH 도어를 열고 RH 창문을 완전히 내립니다.
  2. 동승석 시트를 완전히 앞으로 이동합니다.
  3. RH 2열 시트를 이지 엔트리 모드로 이동합니다.
  4. RH 2열 시트 트랙 위치 센서 전기 커넥터를 연결 해제합니다.
  5. RH 2열 시트 트랙 위치 센서를 시트 어셈블리에 고정하는 볼트를 탈거한 다음 어셈블리에서 센서를 탈거합니다.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 소켓
    • 각도 측정 토크 렌치
    • 2인치 익스텐션

Install

Installation procedure is the reverse of removal.