2025-01-03

Sensor - Relative Humidity and Temperature (HW3) (Remove and Install)

Correction code 10206001 0.55 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

그래핀 블록 교체

  1. ESD 손목 스트랩을 준비해 착용합니다. 정전기 방전 도구를 참조하십시오.
  2. 온도 및 습도 센서에서 그래핀 폼 블록을 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    필요한 경우 접착제 주변 영역에 열을 가하고 핀셋으로 블록을 부드럽게 들어 올립니다.
  3. IPA 천을 사용하여 온도 및 습도 센서 폼 블록을 놓을 부분을 닦아내고 1분 동안 건조시킵니다.
  4. 폼 블록 로케이터 도구를 온도 및 습도 센서에 고정합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    기준점을 보드 구멍에 맞춰 정렬합니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • M3 THS 폼 고정구 - 1727102-00-A
  5. 트위터를 사용하여 새 그래핀 폼 블록(1110914-00-D)을 온도 및 습도 센서에 장착합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    폼이 도구와 단차가 맞는지 확인하십시오.
  6. ESD 손목 스트랩을 탈거합니다.