NVH Insulator - 3rd Row Seat (Remove and Replace)
Correction code
13060052
0.60
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 3열 카펫을 탈거합니다. Carpet - 3rd Row (Remove and Replace)을(를) 참조하십시오.
- 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
- 12V 전원을 연결 해제합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
-
HVC 로직 전기 커넥터를 연결 해제한 다음 로직 캡을 장착합니다.
-
3열 NVH 절연체를 탈거합니다.
Install
-
3열 NVH 절연체를 장착합니다.
-
로직 캡을 탈거한 다음 HVC 로직 전기 커넥터를 연결합니다.
참고커넥터를 정렬한 다음 핸들을 잠금 위치까지 당겨 커넥터를 완전히 안착시킵니다.
- 12V 전원을 연결합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
- 후면 후드 내 에이프런을 장착합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
- 3열 카펫을 장착합니다. Carpet - 3rd Row (Remove and Replace)을(를) 참조하십시오.