Bracket - License Plate - Rear (NA) (Remove and Replace)
Correction code
12072312
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
-
Remove the screws (x2) that attach the
rear license plate bracket to the vehicle, and then remove the bracket from the
liftgate.1.2 Nm (.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- Torx T20 소켓
Install
-
Inspect and clean the install area on
liftgate.
참고Verify that thread inserts were not damaged during removal, and clean off the surface area from any dirt and debris.
-
Position the rear license plate bracket to the liftgate, and then install the screws
(x2) that attach the bracket to the liftgate.1.2 Nm (.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- Torx T20 소켓