Latch - Door - Front - LH (Remove and Replace)
Correction code
11351002
0.54
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
- 2025-06-25: LV 배터리를 연결 해제하는 단계를 추가했습니다.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| LH 전면 도어 래치를 도어에 고정하는 볼트 |
![]() 10 Nm (7.4 lbs-ft) |
|
Reuse |
Remove
- LH 전면 도어 트림 패널을 탈거합니다. 참조 항목: Panel - Door Trim - Front - LH (Remove and Install).
- 도어에서 LH 전면 도어 내측 벨트 씰을 탈거합니다. 참조 항목: Seal - Inner Belt - Front Door - LH (Remove and Replace).
- LH 전면 도어 글라스를 탈거합니다. 참조 항목: Glass - Door - LH - Front (Remove and Replace).
- LV 배터리 전원을 연결 해제합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
- 전면 LH 도어 클로즈아웃 패널을 탈거합니다. 참조 항목: 클로즈아웃 패널 - 도어 - 전면 - LH(탈거 및 교체).
-
커넥터 잠금 장치를 분리한 다음 LH 전면 도어 래치 커넥터를 연결 해제합니다.
-
래치를 후면 도어에 고정하는 볼트를 탈거합니다.
10 Nm (7.4 lbs-ft)TIpUse of the following tool(s) is recommended:- Torx T25 소켓
-
도어를 통해 래치 케이블 그로밋을 누르고 개구부를 통해 케이블을 안으로 이동시키면서 동시에 도어에서 래치를 탈거합니다.
Install
Installation procedure is the reverse of removal, except for the following: